Erwin P.
- Total activity 11
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by Erwin P.-
How many channels are required for a multi-sensor camera on an NVR or decoder?
Summary This article outlines the channel requirements for multi-sensor cameras when registered on an NVR or decoder. Channel Requirements Each sensor in a multi-sensor camera typically requires on...
-
WRR-5301/5501 - BIOS Boot Sequence
This quick guide will help setup the BIOS Boot Sequence for setting up a new bootable OS SSD/Hard Drive. * This guide only applies to Wave WRR-5000 Series Servers. Step 1 - Enter the BIOS by pr...
-
How to add a multicast stream to WAVE
Applies to Models: WAVE Summary Video Management Systems (VMS) capture IP video streams from various sources such as cameras, NVRs, and DVRs. These streams are typically unicast, meaning that the c...
-
How to Enable On-Screen Display on AHD Cameras
Applies to: Pentabrid Hybrid DVRsIn an effort to maintain standards, Hanwha uses the web UI for all knowledge base articles pertaining to product configuration. Open Chrome, enter the IP Address ...
-
Wisenet WAVE: Icons
Applies to: WAVESummaryThis article describes the various icons and their meaning in Wisenet WAVE.WAVE IconsWAVE VMS displays features and condition with Icons. Below is a list of icons available a...
-
How do I install my Hanwha branded DELL server?
Applies to: All rack-mountable Hanwha-branded DELL serversWARNING:The steps below are for instructional purposes or emergency use only.Hanwha Vision America recommends that only a qualified IT Prof...
-
Why is the MegaRAID repair drive labeled as foreign or unconfigured?
Applies to: WAVE servers with Avago MegaRAID controller installedIssue SummaryThe hard drive appears as foreign or unconfigured in a MegaRAID system. This article provides troubleshooting steps to ...
-
How to replace WRR-5501 Server Back Plane
Applies to Models: WRR-5501 Summary This article explains how to replace the backplane of a WRR-5501. Replacing the Back Plane Fan Assembly Removal To remove the fan assembly: Remove the fan brack...
-
(Discontinued) How to re-seat the CMOS battery and System Memory (RAM modules) in WRR-5501
Applies to Models: WRR-5501; this article does not apply to Dell-built P or Q series ServersSummaryOver time, certain parts of the server may need to be re-seated to restore normal function. This a...
-
WAVE: How to run the Diagnostics Quick Test on a Dell-built WRT-P WAVE Server
Applies to Models: Dell-built WRT-P WAVE ServersSummaryIf you experience hardware-related issues with a Hanwha/Dell-built WAVE Server, you must provide an ePSA report from the WRT-P. The ePSA hardw...