In an effort to maintain standards, Hanwha uses the web UI for all knowledge base 
articles pertaining to product configuration. Open Chrome, enter the IP Address 
of your device into the URL bar, and click Enter. If you are not using the web UI 
to configure your device, please refer to the user manual for your product. 

Applies to Models: ARN, QRN, XRN, PRN, and HRX series recorders

Summary

Newer Hanwha Vision Recorders support scheduling email alerts generated by events from the NVR, these instructions will take you through enabling this function.

NOTE: This article only covers setting up email notification events. You must 
first set up the email section of the recorder and verify its functionality.

Scheduling Email Alerts

To schedule email alerts:

1. Go to Setup > Event > Schedule, then click Add.
   
   
    
2. Give the schedule a name and click Apply. 
   
   
    

3. Select the schedule you just created.

   NOTE: The scheduling screen goes by military time in hours only, 0 
   representing midnight, 23 representing 11 pm

4. Deselect any hours that are orange to turn OFF scheduling at those hours.
   
   
    
5. Go to Setup > Event > Event Setup > Event Rule Setup, then click Add.
   
   
    
6. Select Create Rule.
    
7. Enter the Rule name.
    
8. Click Add trigger.
    
9. Select the Trigger Type to use (ex: IVA or Motion Detection).
    

10. Select the trigger to use.

    NOTE: If you select a trigger type such as motion detection, you must then 
    select the cameras that will receive the alerts.
    

11. Select the Action named E-Mail.
     

12. Check the box next to the Email Group or individual E-Mail to send a Scheduled Alert to.
     

13. Select the Schedule you created in Step 2, then click Apply.