Applies to Models: ARN, QRN, XRN, PRN, and HRX series recorders

In an effort to maintain standards, Hanwha uses the web UI for all knowledge base 
articles pertaining to product configuration. Open Chrome, enter the IP Address 
of your device into the URL bar, and click Enter. If you are not using the web UI 
to configure your device, please refer to the user manual for your product. 

Summary

This article explains how to change a camera IP address or resolve an IP conflict on cameras connected to an NVR.

Changing a Camera's IP

To change a camera's IP or resolve an IP conflict:

1. Go to Setup > Camera > Register. 
    

2. Click Auto Detect. 
   
   
    

   The recorder will search the Network 1 adapter only for any Hanwha Wisenet Cameras.

   IMPORTANT: This tool may detect third-party cameras. Do not use it to add them.
   It supports only the Wisenet protocol. To add third-party devices, use the ONVIF
   protocol and click the Manual button to register them.
   

3. Check the box next to the cameras to change the IP, then click Change IP.
   
   
    
4. Select the Use the Following IP Address radio button.
    
5. Enter the appropriate IP address information.
   
   When changing multiple device IPs, enter only the starting IP address. The system will assign the remaining IP addresses sequentially from that starting address.
    
6. Enter the ID of admin and the password for this account.
   
   If the camera in question is in a default state, use 4321 as the password.
    
7. Click Apply.
   
   
   
   If the credentials are correct, the system will successfully assign the IP address. You can then register your cameras.