Applies to: All Hanwha Vison America NVRs not running Linux or Windows

In an effort to maintain standards, Hanwha uses the web UI for all knowledge base 
articles pertaining to product configuration. Open Chrome, enter the IP Address 
of your device into the URL bar, and click Enter. If you are not using the web UI 
to configure your device, please refer to the user manual for your product. 

Summary

This article provides instructions for registering cameras from third party manufacturers with Hanwha NVRs.

NOTE: All Hanwha NVRs with built in POE switches have Plug and Play
(PnP) enabled by default. These recorders are identified by the "S" 
at the end of their model number (for example: QRN-1610S).

Adding a Third-party Camera

Prerequisites

Before registering a camera, make sure it supports the ONVIF protocol:

• Contact the manufacturer of your device and verify that your third-party camera supports the ONVIF protocol. In most cases, Hanwha Support does not have this information.
   
• Alternatively, you can download ONVIF Device Manager and use it to determine if your device works with ONVIF.

Registering a Third-party Camera

To register a third-party camera:

1. Navigate to Setup > System Management > Settings on your NVR.
    
2. Next to Camera registration method, uncheck Enable PnP Mode.
   
   

3. Navigate to Camera > Register.

   WARNING: Popular brands of third-party cameras may be 
   discovered using the Auto detect button. However, our 
   Auto detect button is set to register a camera using 
   our proprietary protocol by default, which will cause 
   the camera to register but not work.

4. Click the Manual button.
   
   
    

5. On the Manual tab, enter camera details:
   
   Select the ONVIF radio button for Protocol.

   NOTE: ONVIF requires the Time, Date, and Daylight Savings 
   be synchronized between the NVR and the camera in question.

   Enter the IP address of the camera.
   
   Set the ONVIF port to 80.
   
   If the camera is a multi-channel camera, enter the Channel to register.

   NOTE: For third-party multi-sensor cameras, register each
   channel manually, on at a time. 

   Enter the proper credentials for your camera.

   NOTE: If your camera manufacturer requires separate 
   credentials for ONVIF, enter those in the ID and Password 
   fields.

6. Click Apply to begin the registration process
   
   
7. Once you have finished registering all camera(s), click Ok to finalize the changes.