Applies to: All Hanwha Vision America NVRs

In an effort to maintain standards, Hanwha uses the web UI for all knowledge base 
articles pertaining to product configuration. Open Chrome, enter the IP Address 
of your device into the URL bar, and click Enter. If you are not using the web UI 
to configure your device, please refer to the user manual for your product. 

Summary

In the setup of your NVR, you may need to raise or lower key camera settings to save recording space or alleviate network congestion due to the high bit rate usage of higher megapixel cameras. This article covers setting the frames per second, bit rate, and resolution on Hanwha camera profiles via a browser connection to your NVR. 

NOTE: ONVIF registered third party cameras require you to log in and set their resolution,
frame rate, and bit rate in their respective camera interface, since ONVIF does not
provide this functionality.

Adjusting Settings

To adjust settings:

1. Log in to your NVR via Chrome.
    
2. Navigate to Setup.
    
3. Select Camera > Camera setup.
    
4. Change the Frame Rate, Bit Rate, and Resolution to what you need.
    
5. Click OK to save all changes.