Lens moisture at 1st installation of NW camera

1. Applied model
- Network cameras( PTZ Camera , Bullet Camera , Dome/Vandal Camera)

2. Guide for initial installation
- Moisture on the lens surface may be observed right after initial installation of network
  cameras with power supplied
- Desicant adsorbes the internal moisture and releases back when device temperature is increased
  due to power supply. the moisture on the lens surface would be dried out in 2~3days.
- This moisture can be observed to gore vent applied product as well, and it is not a defect symptom

3. New desicant DesiKhan
- Granule type made of natural mineral combination service time extended more than 3times

	Image	Remark
New desicant		. Moisture is solidified through a chemical reaction during moisture   absorption to minimize re discharge during drying out . Absorbs moisture about 80~110% of its own weight and releases   about 20~30% of the absorbed moisture back to outside . Needs to be replaced if device was remained in stock for more   than 12 month
Part#	DesiKhan 2.5g (PM02-006317A 2ea packing, PM02-006172A 50ea packing) DesiKhan 5g (PM02-006316A 2ea packing, PM02-006173A 50ea packing)

4. Gore Vent applied models
- By applying Gore Vent, product air permeability is increased to maintain internal and
  external pressure balance, prevent penetration of contaminated particles, and minimize
condensation. Do not attach decicans to products applied with Gore Vent