Relay control on PNO-A9081RLP Road-Ai Camera

Many Wisenet cameras offers alarm inputs and outputs, these are TTL outputs and are not volt free, a transistorised relay is required to obtain a volt free output.

The PNO-A9081RLP Road-Ai ANPR camera has a 12V 50mA supply capable of powering the below transistorised relay, therefore an additional power supply for the transistorised relay is not required.

Important Information.

1. The PNO-A9081RLP has a total budget of 50mA, therefore only one relay can be directly powered from the camera.

• In the below example we have a relay connected to the alarm output wire of the camera (BROWN wire).
• A 47KΩ resistor is required to be connected in series on the I/O trigger wire.

Note - without the 47KΩ resistor in place, the relay will always be energised and the camera will have no control. 

Note - The jumper must be set to L for proper operation.

Camera wires

Green wire - 12V 50mA

Black wire - 0V

Brown wire - Alarm Output (BARRIER CONTROL)

Orange wire - Alarm Input

Camera Configuration.

• Navigate to the camera webpage, Settings, Event, Alarm Output.

• In this example, we have configured the alarm output configured as N.O. Normally Open, Mode type as Pulse and Duration of 3 seconds.

Road-Ai App Configuration.

• From the camera webpage, Click on Open Platform, Go App - the Road-Ai application will load in a new webpage.
• Navigate to Settings, scroll to the bottom of the page (Number 1).
• Set the White List Reaction 1 to Open Barrier (Number 2).
• Enter your white list licence plates (Number 3).
• Save settings when finished (Number 4).

The relay used in this example has a total current draw of 50mA, therefore it is suitable to be powered from the camera.

Link to relay used