Elliot Leem

 The below article is a guide for setting up the SolidEdge cameras, PNV-A6081R-E1T and PNV-A6081R-E2T in Wisenet WAVE  Once the camera has been set up and an IP address has been assigned (whether b...

 The HRX will have its DHCP server turned on by default. This can conflict with a routers DHCP server. This can cause devices on the local network to loose their internet connection and cause the W...

 To record cameras only when an alarm input is activated Set the cameras that will be recorded on alarm input to record on Event only in the Record schedule Create an Event rule with alarm input (r...

 Auto Recovery Backup (ARB) recovers recordings from a cameras SD card, due to network disruption between camera and recorder.To set this up, firstl configure the SD card recording settings on the ...

 When upgrading NVRs the upgrade can fail and an error message is displayed 'Upgrade Failure' or not show the USB device being used for upgrade. No HDD fittedOne reason for this could be that a HDD...

 The Vaxtor VaxALPR app can integrate with Hanwha NVRs using the POS integration and Text Search to find the read plates and display the recorded video when the plate was read. Camera settingsIn th...

 To set the North facing direction of a PTZ camera, navigate to:Setup > Video & Audio > Camera Setup - OSDPosition the camera in the direction of North and then press the North Compass button to sa...

  The below article serves as guide to users on how to set up the lenses and use PTRZ on a multi-sensor camera, the PNM-9085RQZ   The PNM-9085RQZ camera has 4x 5MP lenses which can be set up under...

 Devices and software can be checked for ONVIF conformity by visiting: Conformant Products - ONVIF(https://www.onvif.org/conformant-products/) The conformant ONVIF profiles, Software/firmware versi...

 The SPC-2001 can be connected directly to a NVRHowever the SPC has two mode, PTZ mode and general control modeTo toggle between these modes you need to press button no 9When in PTZ mode, you can c...